|
No hay comentarios de productos.
Reinstallation Procedure 1. Remove the Imaging Unit from its aluminum pack. 2. Tilt the Imaging Unit to the left and shake it a small stroke in the tilt direction twice. Then, tilt it to the right and shake it a small stroke in the tilt direction twice. NOTES � Since the Imaging Unit is highly susceptible to light, keep it shielded from light up to the time it is installed. � Carefully unseal the aluminum pack. � If the Imaging Unit is packed in the aluminum package again, seal the package using tape or another means. 3. Remove the protective tapes
4025U024AA
protective tape
C4587U013AA
4. Remove the shipping cushion. CAUTION � Make sure that the protective sheet is rolled up into the Imaging Unit as shown in the <OK>. <OK> <NG> protective sheet
C4587U015AA
protective sheet
NOTE � When installing the Imaging Unit, ensure that the color of the mounting guide of the Imaging Unit is the same as the color of the label at the mounting position on the main unit. 5. Keeping the Imaging Unit in a level position, insert the Imaging Unit into the mounting position all the way until it is stopped. NOTE � Do not allow the Imaging Unit to become tilted while installing them into the Main Unit, as damage to the PC Drum or the LED assembly can result.
4025U028AC
E-24
|
